Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Cap & Crown in Deer Park: What to Know First
We replace and repair Olympia Chimney caps and crowns throughout Deer Park, typically finishing most jobs in a single visit. A standard cap replacement on an Olympia Chimney flue runs $275 to $425 installed; crown work starts around $350 and climbs from there depending on damage. We’re an independent Olympia Chimney service provider, not a manufacturer arm, so the number we quote on the phone is the number on the invoice.
This page is for Deer Park homeowners who own Olympia Chimney products and want straight answers about caps, crowns, and what happens when either one fails. If your cap is rusted through, missing, or your crown is cracked and spalling, call (631) 214-2108. Wendell Pike and his crew have worked on Olympia Chimney setups across Deer Park for years, and we’ll tell you plainly whether you need work done this week or can wait another season.
Key Takeaways
- Olympia Chimney caps and crowns fail in predictable ways in Deer Park’s freeze-thaw winters
- Most cap replacements are done in one visit; crown repairs may need a follow-up for curing
- We carry Olympia Chimney-compatible caps and stainless steel components, plus quality aftermarket options
- Every job is backed by our 90-Day Done Right Promise in writing
- Free estimates, no trip charge inside the county, $40 off any repair over $200
How Olympia Chimney Products Fail - and How We Fix Them
Olympia Chimney builds solid products, but every cap and crown eventually meets a Long Island winter. Here’s what we see most often on Deer Park rooftops.
- Rusted-out galvanized caps on Olympia Chimney flue systems. The original caps spec’d on many Olympia Chimney installations in Deer Park were galvanized steel, not stainless. After five or six winters of snow sitting on the cap, the seams start to go, and then the mesh. We replace these with stainless steel caps sized for Olympia Chimney flue diameters. The fix usually takes under an hour once we’re on the roof.
- Crown spalling from trapped moisture. Olympia Chimney systems with masonry crowns are prone to the same freeze-thaw cracking as any other brand, but we notice it more on Deer Park homes where the crown wasn’t poured with a proper overhang. Water gets under the edge, freezes, and chips the crown away in chunks. We rebuild or recoat the crown and correct the overhang so water sheds away from the flue.
- Damaged spark arrestor mesh on Olympia Chimney caps. The mesh on Olympia Chimney caps does its job until a branch, a hail stone, or a determined squirrel takes a run at it. Once it’s torn, embers have a clear path out. We replace the mesh or the whole cap depending on how the damage looks. On Olympia Chimney’s stainless models, the mesh is often replaceable without swapping the entire cap.
- Mismatched cap sizes from previous repairs. A surprising number of Deer Park homes have caps that don’t actually fit their Olympia Chimney flue. A previous owner or a handyman grabbed something close enough and bolted it on. The result is a cap that shifts in wind and scrapes the flue tile or doesn’t seat properly, letting rain in. We measure the flue properly and install the right Olympia Chimney-compatible cap.
- Crown coating failures on older Olympia Chimney installations. If someone applied a brush-on crown coat in the past, it may be peeling by now. Thin coatings don’t survive Deer Park summers followed by hard freezes. We remove what’s left, repair the crown surface beneath, and apply a proper flexible crown sealer or rebuild the crown entirely when it’s too far gone.
Our Olympia Chimney Chimney Cap & Crown Process
When you call about Olympia Chimney cap or crown work in Deer Park, here’s what happens.
- 1
You call, a person answers. Sometimes that’s Wendell. We’ll ask what’s going on and give you a ballpark number before anyone gets in the truck.
- 2
We come out and look. No trip charge inside the county. We inspect the existing cap and crown, take photos, and show you what we see.
- 3
You get a plain-English verdict. If the cap is fine and the crown has a hairline crack that won’t leak, we’ll say so. If it doesn’t need doing, we’ll tell you that too.
- 4
We make the repair decision with you. For Olympia Chimney systems, we discuss OEM versus quality aftermarket. In most cases, a stainless aftermarket cap sized correctly performs as well as anything and costs less. For crowns, we figure out whether it’s a recoat or a full rebuild.
- 5
The work gets done. Cap jobs are usually same-visit. Crown rebuilds may take a few hours plus a day for curing. We protect the job with a 90-Day Done Right Promise so if anything’s not right, one call brings us back.
- 6
You get the camera report. Before we leave a chimney job, we run the inspection camera and send you the footage with our notes. You see what we saw.
What Olympia Chimney Chimney Cap & Crown Costs in Deer Park
Here are honest numbers for the Deer Park market. These are what we quote before work starts, and they hold.
| Job | Typical Cost |
|---|---|
| Standard Olympia Chimney-compatible stainless cap replacement | $275 - $425 |
| Multi-flue custom cap for Olympia Chimney setup | $450 - $780 |
| Crown recoat and sealing | $350 - $550 |
| Crown rebuild (masonry removal and repour) | $650 - $1,150 |
| Cap plus crown work bundled | $550 - $1,400 |
What moves the price: flue size, roof pitch and access, whether the old crown needs full removal, and whether you want a standard cap or something custom. We don’t charge more because it’s an Olympia Chimney product. Call (631) 214-2108 for an exact quote, or email for a free estimate. It’s free, and you’ll get the number before we touch a tool.
Why Deer Park Homeowners Call Top Hat Chimney for Olympia Chimney Work
Wendell Pike founded Top Hat Chimney in 1999, and he’s still the one answering the phone half the time. We’re not a national outfit that rotates through town with a new crew every season. When you hire us for Olympia Chimney cap and crown work in Deer Park, the same people who quote the job do the job, and they’ll be back next year if you need them.
We work across brands too. If your Olympia Chimney system needs something beyond caps and crowns, we install and service DuraFlex liners, HeatShield resurfacing, and Gelco parts. That means we give you options instead of pushing one brand hard. Every job, including Olympia Chimney cap and crown work, comes with our 90-Day Done Right Promise written on the invoice. If it’s not right, we come back. No argument, no charge. That’s been the deal since 1999.
FAQs
Generally no. Olympia Chimney warranties cover the chimney system itself, not the cap sitting on top of it. As long as the cap is installed properly and doesn’t restrict the flue opening, your warranty stays intact. We size every cap to the flue, and we use stainless steel components that hold up in Deer Park’s climate. If you’re ever unsure, we’ll check the specific model and tell you what matters for your warranty.
Most cap replacements in Deer Park are done in a single visit. We carry common Olympia Chimney flue sizes in the truck. If you need a custom or multi-flue cap, that’s typically fabricated within a week. To schedule a visit, call (631) 214-2108. We’ll give you a real arrival window, and we call if it slips.
If the crown has hairline cracking but the surface is intact and shed water properly, a recoat and seal usually buys you years. If chunks are missing, the overhang is wrong, or you can see the flue tile separating, it’s time for a rebuild. A rebuilt crown costs more than a recoat, but it’s cheaper than a flue liner failure later. We’ll always show you the camera footage and tell you which way to go. You’ll never have to guess.
For many older Olympia Chimney residential systems, yes, replacement components are still available. But sometimes OEM parts are backordered or cost more than they’re worth. That’s where quality aftermarket stainless caps and universal crown sealers come in. We’ll lay out the OEM vs. aftermarket trade-offs with real prices for your specific Deer Park home. You decide.
Once a year, burn or no burn. Chimneys break in the off-season too. In Deer Park, the freeze-thaw cycles do more damage in February than any night fire in January. If you haven’t had your Olympia Chimney cap and crown looked at in a while, call (631) 214-2108. We’ll schedule an inspection and give you a plain-English verdict, with photos to back it up.
Written by Wendell Pike, Owner, Top Hat Chimney - Deer Park, NY at Top Hat Chimney, serving Deer Park and nearby areas.